 |
Mitre Saws
D45A
D45F
D20
N90
Chopper
MN
EMN
MNA
BMS
Chopper
Delux
Rabbett2
T-350
Measurement Systems for Single Cut-Off Saws |
 |
|||||
| VIS
- Vision Gage : Used for measuring inside, rabbet, or outside
dimensions of moulding. Made from new age polycarbonate material.
Lines are printed from the back side and laminated to an aluminum
backer in 1/8” (3mm) increments. Stainless steel wear plates
are attached to table base. Gage is 72” (183cm) long only
and for right hand mounting only.
|
 VIS 
|
|||||
PAS
- Production Mitre Air Stop :
For continous multiple dimension gaging of different sizes. Stops can be set on 1” (25mm) increments along a standard 6 foot (183cm) fence. 10 foot (305cm) fence optional. By activating an air switch, stop is pushed forward via an air cylinder for a predetermined dimension. To change dimension, push valve switch in opposite direction (stop retracts) and then select another stop length. Three stops are provided on 6 foot (183cm) fence. Four stops provided on 10 foot (305cm) fence. Additional stops are available for extra charge. |
 PAS |
|||||
DIG
- Digital Measuring System : Used for measuring outside or tip-to-tip dimension. The unit can provide size readout in decimal inches, fractions or millimeters by selecting the desired display mode. The DIG is available in 6 foot (183cm) and 10 foot (305cm) lengths. table supports for DIG are available as an optional accesory. |
 DIG |
|||||
|
||||||