Main Menu
Untitled Document



  Mitre Saws

  CTD Saws

     D45A
     D45F
     D20
     N90
     Chopper

  Pistorius

     MN
     EMN
     MNA
     BMS
     Chopper

  Frame Sqaure

     Delux
     Rabbett2

  ITW AMP

     T-350

 

CTD Model D45AX - 14"
High-Top Frame & Notching Saw


 
 
The D45 is popular world wide because of its unique features, low cost and precision. Engineered for higher production, this double mitre saw makes two 45° mitres at one time,
saving time and materials. D45’s are used by thousands in the decorative arts trade throughout the world.
  
       
  Standard Features & Specifications :

Blade Capacity :
Saw blades not included.
14" OD (356mm)

Spindle & Pivot :
Both mounted on pre-loaded and sealed ball bearings.

Model D45AX Automatic
*Optional Extras Available

  
 
Arbor :
5/8” (16mm) with 2-1/4” (57mm) saw collars.

Iron Castings :
 Saw arm, pivot brackets and table are precision machined and ground with milled slots in table to guide pivot brackets and fences.

Motors & Voltages :
2 H.P. (3 H.P. optional) 3 phase 230/460 Volt, Totally Enclosed Fan Cooled Motors, 60 Hz, 3450 RPM with Dual Magnetic Starter. Also includes rotary disconnect switch and blade guard interlock switch. Consult factory for amperage load of motors.

Table Height :
34-1/2” (88cm) from floor.

Floor Stand :
Close coupled heavy gage steel stand completely enclosed with 6” dust outlet. 1200 CFM required.


 
 
Blade Wear & Angular Adjustments :
Each saw head has adjustments for blade variation. Allows for precision alignment of blades to minimize scrap. Saw heads are adjustable up to 3°, always assuring perfect mitres.

Length of Stroke Adjustment :
The D45AX is unique in that the stroke of the machine and the position of the blade above the work can be adjusted to use only the stroke needed to cut a particular moulding or extrusion. Saw heads reverse immediately, thereby saving wasted time and motion.

Production Rate :
The D45AX is capable of cycling at one second intervals. However, actual production rates vary with the type and width of material to be cut.

Size :
Standard machine, without tables or gages; Weight 550 lbs. (250kg); 46” (117cm) Wide x 22”
(56cm) front to back x 51-1/2” (131cm) High.

Crated Size :
45” (114cm) Wide x 28 -1/2” (72cm) front to back x 60” (152cm) High.

Actuation :
Pneumatic foot valve with cover.

Air Pressure:
75 PSI (5.4 kg/cm2) with Air Filter/Regulator/ Lubricator; includes Auto Drain.

Air Consumption :
1.0 CF per 10 strokes at 75 PSI (.043 cubic meters per minute at 5.4 kg/cm2).

 
 

 
   
     
  Footer
Home  |  Contact Us  |  Sitemap 
 
Copyright © 2003 Ultramitre. All rights reserved.